T069 black is not recognized by printer Epson NX300

  • T069 black is not recognized by printer Epson NX300

  • For the issue ,could you try the following instructions to see if it could help work ?

    Remove ALL the ink cartridges from the printer. Make sure all the sealing tapes are removed from the cartridges. Turn it off for a minute and turn it back on then reinstall all the cartridges back into your printer. When installing, make sure you won’t knock out the previously installed cartridges and make sure they are all sitting tightly inside the correct slot. Give them a little push if you have problem installing.

    For T069 on some Epson printer it will also display as “cannot recognize” when out of ink, if cx explain it suddenly stopped printing explain it might be due to this problem. Suggest to use:

    For some Epson printer, since our cartridges are not original, when the cartridge is out of ink, it will display as cannot recognize. We suggest you can install a new cartridge.

    For with chip ink please add:
    It could be possible that the chip or chip sensor area inside the printer is dirty. Clean the chip on the cartridge with an isopropyl alcohol. Remove any debris that is on the chip sensor area inside the printer, by blowing or with canned air.

    For cartridges that has a plastic cover on the bottom:
    Please try removing the cartridge from the printer. Make sure all the sealing tape are removed. Also check the bottom of the cartridge to see if the plastic cover is being penetrated. If the plastic cover is not being penetrated, please in a safe area, use a pointy object (like pen, hair pin, toothpick etc) and gently penetrate it. PLEASE DO NOT remove the plastic cover fully, it might leak and make a mess inside the printer.

    Then reinstall the cartridges make sure they are sitting properly inside the printer.

Log in to reply





Looks like your connection to Shopper+ Forum Canada was lost, please wait while we try to reconnect.